Remove the freezer paper it can be used again. Ease in the fullness, so that you have a smooth circle. I use a stiletto to guide the fabric over the circle. Press the fabric over the edge of the circle with an iron. Using a cotton swab or a paint brush, “paint” the edge of the fabric with starch.Press the freezer paper circle onto the fabric and cut out the circle, leaving a 1/4″ seam allowance.Place another piece of freezer paper (both shiny sides down, not facing each other) over this and press them together. Trace the large circle from the pattern page onto the dull side of the freezer paper.You’ll need the larger circle for the large Dresden. The Dresden blade pattern page has two circles that you can use as the circle template. So, I’ll show you a “freezer paper and starch method” and a hand gathered method. I like the edge of the circle to be turned under rather than a raw edge that is fused. You can choose your favorite applique technique for this. Basically, you’re appliqueing the circle onto the center of the Dresden plate. There are several ways to make the center circle. Press the seams to the side (or open if your prefer).This will be covered up by the center circle. Don’t worry too much about the bottom (narrow) edges lining up.Sew the pairs together to form a Dresden Plate.Make sure they match up well at the top and backstitch at the beginning to secure. Sew the blades into pairs, starting at the wide end.Arrange your blades into a circle so that you’re happy with the color arrangements.Press seam open and align the seam with the center crease and press.Turn right side out and push out the point with a semi sharp object.Press the blade lightly in half to form a centering crease.Make sure not to get too close to the stitching – keep it 1/8″ away. Trim the point of the blade at an angle near the fold to reduce bulk at the point.Chain piece the blades through your sewing machine.TIP: set your stitch length to 1.5 – 2.0 to keep your seam secure. Fold each Dresden blade in half, right sides together.The sample below is using a 3″ wide strip and makes a cute little Dresden. This will just give you a bigger hole (but not too big) in the center (and less stitching to do). Make sure to line up the ruler so that you have part of the small wedge hanging over the edge of the fabric. The same as above, BUT you will be using a ruler instead of a template. Continue cutting until you have 12 blades (for 1 Dresden plate).Position the ruler on the opposite side and cut the second blade. Place the template on the fabric strip so that it’s upside down and one side is lined up with the previous cut edge.You might need to reposition the fabric first to safely cut the second side. Position the ruler on the left side of the template and cut.Position the ruler so that it is even with the right side of the template. Place the template on the fabric strip so that the top and bottom edges of the template are even with the raw edges of the fabric strip.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |